Expansion Sleeve Anchor are widely used in the installation field for the quick and easy function. To drill a hole according to the sleeve dia. size and insert the anchor body inside and fasten the head nut or the bolt assembled to expand the anchor body to fix the objects in the concrete,strong masonry, solid brock or drywall substrate place. a good design with a the plastic ring absorbs material irregularities, in addition,it is a useful damp-proof plece to inner mechanism of the anchor.The steel cone nut has some milled grooves in order to prevent the anchor from loose or spin movement after fixing into the hole and ready to expansion. In order to assure full anchording strength power, do not largen the hole diameter and shake the drill toolings.
Drill the hole at least 5mm anchor diameter deeper than the inserted depth, but not closer than two anchor diameters to the bottom surface in the concrete. Through drilling is allowed when using sleeve anchors in hollow concrete block.
Clean the hole using compressed air and a nylon brush.
3. Drive anchor through the fixture into the hole making sure the nut or head to rest solidly against the fixture.
4. Fasten the nut or head by the tooling till the expanded fully.
|Anchor Size ( mm )|
|M5 X φ6.5 X 18 - 90|
|M6 X φ8 X 25 - 85|
|M8 X φ10 X 40 - 100|
|M10 X φ12 X 60 - 129|
|M12 X φ16 X 65 - 147|
|M16 X φ20 X 75 - 150|
The special size and style are available as the samples and sketches.